Mutli-out connector-ectomy DONE!

I think I'm getting a little better at desoldering pins from a board. Sure, ordering the 3D printed connector would've been loads easier, but the outsourced connector was free...just took some time.

Pardon the blur. This was a sacced Super Famicom. The video on the SuFami was all off. 

The remains. I may see if I can keep this if it's just gonna get tossed.

~30 minutes of work (I was trying to watch a show at the same time). Front of the multi-out.

And the underside. To which...

Some note taking. Doing the whole shebang on this one.

This is gonna be one of the most involved mods I've done so far. Here's to hoping I don't mess it up.